danaxagent.blogg.se - Aeon labs z-stick series 2

#AEON LABS Z STICK SERIES 2 HOW TO#

If your Doorbell 6 has been successfully unpaired from the Z-Wave network, its LED will begin to flash slowly, indicating it is ready to join a Z-Wave network again.Press the Action Button 6 times in 2 seconds.If is fails to join the Z-Wave network, the LED will flash slowly.

If Doorbell 6 has successfully paired to your Z-Wave gateway, the LED will be a solid color for 30 seconds, then turn off.Ensure that Doorbell 6 LED is flashing slowly.Power Doorbell 6 through the provided power adapter.With the LED pulsing, release the Action button, and the Doorbell 6 will be reset to factory defaults.

After 21 seconds, the LED will quickly flash 3 times, and then the LED slowly pulse up and down as you hold down the Action Button.

From 5-10 seconds, the LED will begin to flash faster and faster still from 10-20 seconds.

Within 2-5 seconds, the test doobell sound will run, then stop after 5 seconds has elapsed.

Press and hold the Action button for 20 seconds.

If your Doorbell has been successfully unlinked to your network, its LED will begin to flash slowly indicating it is ready to be paired to a new network.

Press the Action Button on your Doorbell.

From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.

From the device's details page, select Remove Device, then Remove.

If linking was unsuccessful, the LED will flash when you tap its button.

If your Doorbell has been successfully linked to your network, its LED will become solid for 2 seconds, then stop.

Press the Action Button on your Doorbell Gen5, and its LED will flash rapidly to indicate that it is communicating.

See Discovering your devices for detail instructions.

From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.

Your Doorbell will now be reset to its original settings, and the Network LED will be solid for 2 seconds and then start slow flashing as a confirmation.

Press and hold the Action Button for 20 seconds and then release it.

#AEON LABS Z STICK SERIES 2 HOW TO#

See How to Build a Solid Z-Wave Mesh for further detail on methods of Exclusion. If Hubitat Elevation doesn't show Unknown Device Excluded in the log, then the General Exclusion has failed and the device probably won't be able to be joined. Typically the same button on the device for inclusion is also used for exclusion. If a device cannot be factory reset, or is in an unknown state, then it is recommended to do a General Exclusion in your Hubitat Elevation hub to be sure it isn't joined to the former Z-Wave mesh. Exclusion will happen automatically when the device is removed from Hubitat Elevation, however it is recommend that Z-Wave devices always be factory reset as well. While Zigbee devices can simply be removed and put into Paring Mode using the manufacturer's instructions, Z-Wave™ devices must be Excluded from their previous network before joining a new one. Before you can join your devices to your Hubitat Elevation hub, you must first remove them from the previous hub or bridge.